General Information - Aglient Turbo-V 70 PCB Manual De Instrucciones

16 Instructions for Use

General Information

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorised interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 70 PCB controller is a microprocessor-controlled, solid-
state, frequency converter with self-diagnostic and self-protection
features.
It incorporates all the facilities required for the automatic operation
of the Turbo-V 70 PCB pump series. The controller drives (within ten
steps) the Turbo-V 70 PCB pump during the starting phase by
controlling the voltage and current respect to the speed reached by
the pump.
Remote start/stop, pump status signals, forepump start/stop,
interlock control (for pressure switch, water flow switch, etc.)
capability, are provided via auxiliary connectors. The controller
needs to be powered by an external transformer (not supplied with
the PCB).
An hand held terminal is available as an option to control and
display the controller operation. The following paragraphs contain all
the information necessary to guarantee the safety of the operator
when using the equipment. Detailed information is supplied in the
appendix "Technical Information".
224/280 Turbo-V 70 PCB Controller User Manual / 87-900-871-01 (E)