Wire Connection - Broan BPDP1 Serie Manual Del Usuario

RED

WIRE CONNECTION

A
Cut the BLACK wire that is connected to blower switch and light switch.
B
Cap off the BLACK wire connected to the light switch terminal. Connect the RED wire from 14/3 cable to the BLACK wire from the motor
switch, using an appropriate wire nut.
MOTOR SWITCH
TERMINALS
A
BLACK WIRE
MOTOR SWITCH
TERMINALS
B
Once all the connections are done, finalize the installation by reversing steps
R H O
ANGE OOD PERATION
Use the hood control to set or change the blower and light intensities desired; these settings will be applied when using the wall
switches. For example, if the blower is set on high speed using the hood control, when the user presses on the motor rocker switch on
the wall control, the blower will then turn on high speed. If the user wants the blower to turn on low speed, the blower speed must be
changed using the hood control. It is not necessary to turn off the blower to change its speed.
The same procedure applies for the light intensities (when low and high intensities are available).
THIS PROCEDURE APPLIES TO BROAN BPDC1, BPDP1, AND NUTONE NPDP1
R
OCKER SWITCHES
BPDC1
SERIES
LIGHT SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
RED WIRE
FROM 14/3 CABLE
DOUBLE BLOWER RANGE HOOD SERIES.
E
LONGATED ROCKER SWITCHES
BPDP1
AND
A
MOTOR SWITCH
TERMINALS
BLACK WIRE
MOTOR SWITCH
B
TERMINALS
RED WIRE
FROM 14/3 CABLE
 
to on first page.
3
NPDP1
SERIES
LIGHT SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS