Trust ALKCT-2000 Manual Del Usuario página 9

ALKCT-2000 ARM/DISARM REMOTE CONTROL
EN
1. Place battery
Open the battery slot at the back of the ALKCT by sliding it down. Place the included 3V CR2477 battery
and potentially the keychain cord. Close the battery slot. For more information on replacing and
purchasing new batteries visit trust.com/71115
2. LED indicator
Low battery: LED will blink 2x when a button is pushed
Confirm pair/unpair: LED will blink 5x
Successful arm/disarm: LED will light for 1.5 sec
Unsuccessful arm/disarm: LED will blink shortly 3x
3. Activate the pairing mode
Consult the manual of the Siren to activate the pairing mode. Put the ALKCT in pairing mode by first
pressing the ON and OFF button simultaneously for 4 sec (untill the LED of the ALKCT starts blinking).
4. Confirm pairing
After entering pairing mode press the ON button shortly to pair with the Siren. The LED indicator of the
Siren and ALKCT will be flashing 5 times to confirm that the pairing has been done successfully.
5. Arm/Turn on the siren
To arm the siren press the ON button for 4 seconds on the ALKCT.
If the siren is armed successfully the LED of the ALKCT will light up for 1.5 sec.
6. Disarm/Turn off the siren
To disarm the siren press the OFF button for 4 seconds on the ALKCT.
If the siren is disarmed successfully the LED of the ALKCT will light up for 1.5 sec.
7. Activating the unpairing mode
Consult the manual of the Siren to activate the pairing mode. Put the ALKCT in pairing mode by first
pressing the ON and OFF button simultaneously for 4 sec (untill the LED of the ALKCT starts blinking).
1