Digital Signal Processor; Introduction Of Dsp Adjustments - Pioneer AXM-P7050 Manual De Operación

Digital Signal Processor

Introduction of DSP
adjustments
Important
! You can use the following functions only when
the remote control is set to DEQ mode.
! Following functions are effective only when
you connected a Pioneer multi-channel pro-
cessor (DEQ-P7050) to this unit.
By carrying out the following settings/adjust-
ments in order, you can create a finely-tuned
sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Adjusting the time alignment
4 Adjusting the speaker output levels using a
test tone
5 Selecting a cut-off frequency
6 Adjusting the speaker output levels
7 Adjusting 3-band parametric equalizer
Operating the DSP menu
1
1 DSP display
Shows the DSP status.
% Press p to display the DSP function
names.
Press p repeatedly to switch between the
following DSP functions:
Posi (position selector)Fad (balance adjust-
ment)SLA (source level adjustment)DRC
(dynamic range control)D.MONO (dual
monaural)DIRECT (direct)Dolby PL
(Dolby Pro Logic)
All manuals and user guides at all-guides.com
# When playing other than the DVD disc on a
Pioneer DVD player connected with IP-BUS
cable, you cannot switch to DRC or D.MONO.
# To return to the display of each source, press
BAND.
If you do not operate the DSP function within
about 30 seconds, the display is automatically re-
turned to the source display.
Operating the DSP details menu
1 Front left speaker
2 Center speaker
3 Front right speaker
4 Rear left speaker
5 Subwoofer
6 Rear right speaker
% Press p and hold until SP Set appears
in the display, then press p to display the
DSP function names.
After SP Set is displayed, press p repeat-
edly, the following DSP functions appear in
the display:
Note
1 2 3
4 5 6
Section
07
19
En