Elu After-Sales Service - Elu MTS22 Manual De Instrucciones

E N G L I S H
• Set the fence (20) to the required angle.
The angle can be read on the scale (21).
Use the slot edge (22) as a reference.
• Tighten the clamp lever by turning it clockwise.
Adjusting the spark deflector (fig. E)
• Loosen the screw (23).
• Set the spark deflector (24) as appropriate.
• Tighten the screw (23).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Do not apply excessive pressure to
the tool.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate cutting disc. Do not use
excessively worn discs. The maximum rotation
speed of the tool must not exceed that of the
cutting disc.
• Make sure the disc rotates in the direction of the
arrows on the accessory and the tool.
• Secure the workpiece.
• Always set the spark deflector correctly.
Switching ON and OFF (fig. A)
The ON/OFF-switch (1) of your chopsaw is mounted
in the control handle (2).
• To run the tool, press the ON/OFF-switch (1).
• Keep the ON/OFF switch depressed while pulling
down the control handle (2) to cut the workpiece.
• To stop the tool, release the switch. The tool will
automatically travel to its rest position.
Do not switch the tool ON or OFF when
under load.
Do not cut magnesium.
Consult your dealer for further information on the
appropriate accessories.
en - 5
Transport (fig. H & I)
Your Elu power tool is equipped with a lock-down
pin (29) which locks the tool in closed-down position
for carrying.
• Lower the guard (4) onto the cutting table (9) and
secure the Power Tool in this position by pushing
in the lock-down pin (29) (fig. H).
• Transport the power tool using the carrying
handle (3).
• To release the tool, pull out the lock-down pin (29)
(fig. I).
Maintenance
Your Elu Power Tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an Elu authorized repair agent
where it will be disposed of in an environmentally
safe way.

Elu After-Sales service

All Elu Power Tools are thoroughly tested before
leaving the factory. However, if the Power Tool
needs repair, please contact your dealer or the Elu
Head Office for the address of the nearest Elu
authorized repair agent (please refer to the back of
this manual).
16