®
Carbon clutch cover - matt finish
Description:
Applications:
GSX-S1000/F AL6
Ref.
Description
Part List
1.
Carbon clutch cover
2.
Mounting instructions
3.
Glue
Ref.
Description
Tools Required
A
Adhesive tape
!
WARNING /
!
CAUTION / NOTICE / NOTE.
Important
Please read this manual and follow its instructions carefully. To emphasize special
information, the symbol
have special meanings. Pay particular attention to messages highlighted by these
signal words:
Indicates a potential hazard that could result in death or serious injury.
Indicates a potential hazard that could result in minor or moderate injury.
Indicates a potential hazard that could result in vehicle or equipment damage.
NOTE: indicates special information to make maintenance easier or instructions
clearer.
1
SUZUKI Deutschland GmbH, Suzuki-Allee 7, D-64625 Bensheim
MOUNTING INSTRUCTIONS
990D0-04K25-CRB
Part Number:
Mounting Time:
Qty.
1
1
1
A
!
and the words WARNING, CAUTION, NOTICE and NOTE
WARNING
!
CAUTION
!
NOTICE
Precautions for
Installation
15 Min
Mounting
1. Check that the kit includes all the parts listed on the first page.
2. Check each part in the kit for scratches or any form of damage.
3. Park the vehicle on level ground.
4. Remove the ignition key from the switch and store it in a safe place.
5. Protect any items removed or to be installed from scratches by placing them on
a soft cloth first before putting them on the ground.
6. Use care not to cause any damage to the body of the vehicle during installation
of the accessory.
CAUTION
!
If you do not feel technical qualified to install this product on your own,
please consult with your nearest SUZUKI dealer.
1. Allow the engine/exhaust to cool prior to installation.
2. Read these instructions carefully before assembly and examine whether all
parts are enclosed in accordance with the parts list.
3. Before gluing the carbon clutch cover , the surface of original clutch cover must
be clean, dust-free and free of grease.
4. Apply the glue (3) on the original clutch cover as you can see in picture 1.
5. Place the carbon clutch cover (1) in correct position as you can see in
picture 2 and 3.
NOTE: Check that the hole in the carbon clutch cover is centered with the clutch
release cap.
See detail in picture 3.
6. Fix it with tape (A) as you can see in picture 4.
CAUTION
!
After gluing the carbon cover, please wait 24 hours until the glue has become dry.
CAUTION
!
Pay attention, that the adhesive tape has been removed before the engine gets started.
SUZUKI GENUINE ACCESSORIES
12/2015 ENG