Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Locating with the Receiver
1. Turn the Receiver on by pressing the
power button for two seconds.
2. Match the frequency of the Transmitter
by pressing "Hz" repeatedly (either 8 kHz or
33 kHz depending on Transmitter setup).
3. Follow the steps as described in
"Locating with the Receiver"
(Pg 2-4).
500
©2018 Beha-Amprobe
©2018 Beha-Amprobe
For detailed specifications and ordering go to beha-amprobe.com 6011426 A
For detailed specifications and ordering go to beha-amprobe.com 6011426 A
®
®
4. Use the arrow indicators to quickly assess
location of the wire (optionally, measure the
depth of the wire – refer to the User Manual
for more details).
Note: When using the Signal Clamp, it
is best if both ends of the target cable are
grounded to enable the current to flow.
Quick Guide
11
Publicidad
Tabla de contenido
