Forch 5339 2 Manual De Instrucciones página 76

If accessories shorter than the mandrel are used (A2-3), insert suitable spacer rings.
Only then can the accessory be properly secured.
Work instructions:
Sanding, polishing, working with wire brushes:
Press the machine down moderately and move it back and forth across the surface.
11. Troubleshooting
The electronic signal indicator (A1-4) lights up and speed decreases.
Excessive load on the machine! Allow the machine to run idle until the electronic
signal indicator switches off.
The machine will not start. The electronic signal indicator (A1-4) is flashing.
The restart protection is active. If the mains plug is plugged in while the machine is
switched on or the power supply is restored after a power failure, the machine will not
start. Switch the machine off and on again.
12. Maintenance
Before any maintenance work: Remove the plug from the socket!
Particles may be deposited inside the electric tool while working which impairs the cooling
of the electric tool. Conductive deposits may impair the protective insulation of the electric
tool and lead to electrical hazards.
Frequently, regularly and thoroughly vacuum the electric tool through all the front and rear
ventilation slots, or blow it out with dry air.
Disconnect the electric tool that need repair from the power supply beforehand and wear
protective goggles and a dust mask.
13. Repair
Repairs to electric tools may only be performed by a qualified electrician! If the
connection cable is damaged, it must be replaced by a specific connection cable.
For repairable FÖRCH electric tools, please contact your local dealer.
14. Environmental protection
The resulting grinding dust may contain hazardous substances and must be correctly
disposed of.
Follow the national regulations for the environmentally responsible disposal and recycling of
old machines, packaging and accessories.
Only for EU countries: Do not dispose of electric tools with household waste! In
accordance with European Directive 2002/96/EG on disused electric and electronic
devices, and its transposition into national law, old electric tools must be disposed
of separately and sent for environmentally responsible recycling.