SCHOLTES PP 40 DCDR F Serie Manual De Instrucciones página 16

FOR MODELS: PP 40 DCDR F ... - PP 40 TCF FOR MODELS: PP 40 DCDR F ... - PP 40 TCF FOR MODELS: PP 40 DCDR F ... - PP 40 TCF FOR MODELS: PP 40 DCDR F ... - PP 40 TCF FOR MODELS: PP 40 DCDR F ... - PP 40 TCF
GB GB GB
GB GB
R=5 mm
H=2.5 mm
Fig. 4a
3 3 3 3 3 - Sit-on hobs (Class 1) with edges higher than 77*/
87**/90*** mm (see Figure 2, detail H3); in this
case, the lower casing of the hob does not
protrude further than the edge of the appliance.
Even when the hob is resting on the worktop, it
will suffice to leave space for the gas supply tube
and electricity supply cable.
To fit this type of hob, follow the instructions
below (Fig. 5):
• Fix the two screws provided "A" at a distance
from the back panel as shown in Figure 5, leaving
the heads of the screws sticking out of the wood
by 1.5 mm.
• Hook the hob onto the two screws "A" and push it
towards the back.
• Fix the appliance to the cabinet at the rear, using
the two brackets "B" and the four screws "C"
(these are all provided).
16
FOR MODELS: PP 40 DCDR SF... - PP 40 TC SF... FOR MODELS: PP 40 DCDR SF... - PP 40 TC SF... FOR MODELS: PP 40 DCDR SF... - PP 40 TC SF... FOR MODELS: PP 40 DCDR SF... - PP 40 TC SF... FOR MODELS: PP 40 DCDR SF... - PP 40 TC SF...
Fig. 4b
Fig. 5
N.B.: To maximise the efficiency of all technical
maintenance procedures, the area around the hob
must be easily accessible after it has been installed
(i.e. there should be no completely closed-off
elements).
X mm
X mm