Install The Spool; Remove The Trimmer Head - GreenWorks 21142 Manual Del Operador

EN
Use only with the nylon cutting line of 0.08" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
Guide slot
5. Do not wind the lines beyond the edge of the spool.
11.5

INSTALL THE SPOOL

1. Put the new spool in the spool cover.
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
2. Put the ends of the cutting lines through the holes.
NOTE
Top
NOTE
English
3. Extend the cutting line to release it from the guide slot in
the spool.
4. Push the tabs and install the spool cover onto the spool
retainer.
5. Push the spool cover until it clicks into position.
11.6

REMOVE THE TRIMMER HEAD

1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head counterclockwise to loosen it. Do
not remove the spacer from the shaft.
10