Prior To Operation - DeWalt DWE4202 Traducido De Las Instrucciones Originales

1. Thread the wheel on the spindle by hand.
2. Depress spindle lock button and use a wrench
on the hub of the wire wheel or brush to tighten
the wheel.
3. To remove the wheel, reverse the
above procedure.
NOTICE: Failure to properly seat the
wheel hub before turning the tool on may
result in damage to tool or wheel.
Fitting and Removing a
Backing Pad/Sanding Sheet (fig. 1, 6)
1. Place the tool on a table or flat surface, with the
guard facing up.
2. Remove the backing flange (D).
3. Place the rubber backing pad correctly onto the
spindle (B).
4. Place the sanding sheet on the rubber
backing pad.
5. While depressing spindle lock (A), thread clamp
nut (R) on spindle, piloting the raised hub on the
clamp nut into the centre of san ding disc and
backing pad.
6. Tighten the threaded clamp nut (R) with the hex
key provided or a two pin spanner.
7. Release the spindle lock.
8. To remove the rubber backing pad, loosen
the threaded clamp nut (R) with the hex key
provided or a two pin spanner.
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle
without the use of the spacer and threaded flange.

Prior to Operation

• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly. Follow the instructions given in the
Grinding and Cutting Accessory Chart.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and
the tool.
• Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad
for cracks, tear or excess wear, wire brush
for loose or cracked wires. If power tool or
accessory is dropped, inspect for damage
or install an undamaged accessory. After
inspecting and installing an accessory, position
yourself and bystanders away from the plane
of the rotating accessory and run the power
tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart
during this test time.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
WARNING:
• Ensure all materials to be ground or cut
are secured in place.
• Secure and support the workpiece.
Use clamps or a vice to hold and
support the workpiece to a stable
platform. It is important to clamp and
support the workpiece securely to
prevent movement of the workpiece
and loss of control. Movement of the
workpiece or loss of control may create
a hazard and cause personal injury.
• Support panels or any oversized
workpiece to minimize the risk
of wheel pinching and kickback.
Large workpieces tend to sag under
their own weight. Supports must be
placed under the workpiece near the
line of cut and near the edge of the
workpiece on both sides of the wheel.
• Always wear regular working gloves
while operating this tool.
• The gear becomes very hot during use.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Always install the guard and
appropriate disc or wheel. Do not use
excessively worn disc or wheel.
• Be sure the inner and outer flange are
mounted correctly.
• Make sure the disc or wheel rotates
in the direction of the arrows on the
accessory and the tool.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
english
49