Assembly Instructions - Classic Accessories Universal SL Snow Thrower Cab Instrucciones Y Cuidado

STEP 1
ASSEMBLE THE FRAME (FIG. 1-2)
ASSEMBLE THE HOOP (FIG. 3-4)
WARNING!
Use care when assembling the hoop side and top poles. Poles under tension can slip out of the metal/pvc
sleeves causing serious injury. Safety goggles are recommended.
PARTS NEEDED
A
B
1
A
Place the center frame bar [A] on the ground with the holes on
the vertical stub tubes on the bottom as shown above.
Insert a side frame bar [B] into the center frame bar [A]
until the spring button pops through hole in the center
frame bar. Repeat with remaining side frame bar.
3
H
I
Lay the hoop poles on a flat surface to assemble.
Connect the seven hoop poles [H], [I], [F],[G] together as shown
above. The plastic PVC sleeve of pole [F] must attach to pole [G].
CLASSICACCESSORIES.COM
E
+
B
B
Plastic PVC Sleeve
F
F G H
2
Insert a vertical post [E] into the frame bar [A] making
sure the notch in the post is at the top.
Repeat with remaining vertical post.
4
G
F
I
G
H
Complete pole assembly
shown above.
Grasp the hoop pole assembly by
the outside set of poles and bend
into a curve.
4
TOOLS NEEDED
I
NONE
E
E
5
F
I
H
H
E
While grasping both ends of the
assembled hoop, insert poles into
the ends into the vertical posts [E].
H
E