Stanley FATMAX KFFMES650 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
ENGLISH
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
:
Warning! Always wear a dust mask when using
this tool.
6
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
#
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Variable speed dial
3. Super-lok
Tool free accessory clamping lever
TM
4. Sanding base
5. Dust extraction adapter (fi g. E Where supplied)
6. Tooled accessory adapter (spacer)
7. Tooled accessory adapter (Fixing bolt)
8. Cut/Depth guide)
6
(Original instructions)
Accessories
This tool includes some or all of the following accessories.
The performance of your tool depends on the accessory used.
Stanley Fat Max accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
Precision plunge cut saw blade for
wooden materials, soft plastics.
(Part number - STA26105-XJ)
Separating, plunge and fl ush cutting
of wood and soft plastics. Ideal for
working on doors, skirting boards,
windowsills and fl ooring.
Plunge cut saw blade for wood and
metal.
(Part number - STA26110-XJ)
Separating, plunge and fl ush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions,
nails and screws.
Plunge cut saw blade for wood and
metal.
(Part number - STA26115-XJ)
Separating, plunge and fl ush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions.
Segmented saw blade.
(Part number - STA26120-XJ)
Long life blade which is ideal for
cutting wood, plastics, thin walled
ferrous and non-ferrous material.
Rigid scraper.
(Part number - STA26135-XJ)
Ideal for removal of hard and soft
material from fl at surfaces such as
the removal of vinyl fl ooring, bonded
carpet adhesive, tile fl oor adhesive,
grout, paint and varnish.
Flexible scraper.
(Part number - STA26140-XJ)
Ideal for removal of elastomer
materials from hard fl at surfaces in
diffi cult to reach areas such as silicon
sealant and other caulking materials.

Publicidad

Tabla de contenido
loading

Tabla de contenido