Stanley FATMAX KFFMES650 Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
Assembly
Fitting and removing the accessories (fi g. A - G)
Warning! Before fi tting an accessory, disconnect the tool from
the mains supply.
Fitting a Stanley Fat Max accessory (fi g. A - C)
Hold the tool and squeeze the accessory clamping lever
(3).
Slide the accessory (9) between the shaft and the acces-
sory holder making sure the accessory engages all eight
pins on the holder and is fl ush with the shaft.
Release the accessory clamping lever.
Note: Some accessories, such as scrapers and blades can be
mounted at an angle if required (fi g. C).
Removing a Stanley Fat Max accessory accessory (fi g. A)
Hold the tool and squeeze the accessory clamping lever
(3).
Pull the accessory from the tool making sure the acces-
sory dis-engages from all eight pins on the holder.
Release the accessory clamping lever.
Warning: Gloves must be worn when removing accessories
as then may become hot during use.
Carbide grout removal blade.
(Part number - STA26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
fl at surfaces and for fast stock
removal of wood, chipboard and
fi breglass.
Carbide rasp.
(Part number - STA26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fi breglass.
Sanding Sheets.
(Part number - STA32348-XJ)
Various grades for sanding of wood,
painted and varnished surfaces.
(Original instructions)
Fitting a sanding sheet (fi g. D)
Line up the sanding sheet (10) with the sanding base (4)
as shown.
Press the sheet fi rmly and evenly onto the sanding base,
making sure that the holes in the sheet coincide with the
holes in the base.
Removing a sanding sheet
Pull the sanding sheet off the sanding base (4).
Warning! Never use the sanding base without a sanding
sheet or accessory in place.
Fitting the dust extraction adaptor (fi g. E)
Line up the dust extraction adaptor (5) with the sanding
base (4) as shown.
Press the adaptor fi rmly and evenly in to the sanding
base.
Secure the adaptor by turning the locking nut (11) clock-
wise.
Connect a vacuum cleaner to the dust extraction adaptor.
Removing the dust extraction adaptor
Turn the locking nut (11) anti-clockwise.
Pull the dust extraction adaptor (5) out of the sanding
base (4).
Fitting the depth/cut guide (fi g. F)
The depth/cut guide allows you to precisely cut material at a
specifi ed depth and more accurately track a marked cut line.
Attach the depth/cut block (8) by inserting the tabs on the
guide into the slots on the main body.
Secure the block to the main body with the bolt (12) and
tighten with the supplied hex wrench.
Insert the guide (13) into the requried position and secure
by turning the depth/cut adjustment knob (14) clockwise.
Fitting alternative accessories (fi g. G)
Place the spacer (6) onto the collar (15).
Place the alternative accessory (16) onto the collar (15).
Firmly attach the fi xing bolt (7) into place to ensure a tight
fi t for the alternative accessory (16).
Note: The spacer and fi xing bolt are not used to attach Stan-
ley Fat Max accessories. Stanley Fat Max accessories are
attached using the Super-lok
lever.
ENGLISH
Tool free accessory clamping
TM
7

Publicidad

Tabla de contenido
loading

Tabla de contenido