Publicidad
Enlaces rápidos
EN
Introduction
This product integrates four-beam infrared sensors, widely used as
a perimeter guarding device in gated houses, shops and indoor
garages. The product requires to be paired to the K1/K2 hub. When
an intruder walks past the detection area and two or more light
beams have been blocked, the sensors will immediately send a
warning signal to the K1/K2 hub.
Product Overview
Transmitter (T)
Upper installation
Waterproof
cap (removable)
rubber plug
Receiver (R)
Transmitter
Beam transmitter
Receiver
LED light
Beam receiver
Buzzer
Lower installation cap
Beam bar
(fixed, non-removable)
Battery
Power output setting switch
Battery
Installation mode switch
EN
Publicidad
Manuales relacionados para Smanos BM-20
Resumen de contenidos para Smanos BM-20
- Página 1 Introduction Product Overview This product integrates four-beam infrared sensors, widely used as a perimeter guarding device in gated houses, shops and indoor garages. The product requires to be paired to the K1/K2 hub. When an intruder walks past the detection area and two or more light Transmitter (T) beams have been blocked, the sensors will immediately send a Upper installation...
- Página 2 The sensors need to be paired to the K1/K2 Hub first before use. To Remove the upper installation caps (marked UP) and waterproof pair the sensors, please refer to the smanos home app accessories rubber plugs on both the transmitter and the receiver, pull out page, press the "+"...
-
Página 3: Installation Mode
To initiate installation, set the Sensors to installation mode from transmitter with screws. the smanos home app on the IR beam sensors page or press the installation mode button in the receiver circuit board, then put it 3. Adjust the receiver on the other side of the detection area. Make back into the beam bar. -
Página 4: Changing Batteries
4. When the buzzer stops, arm the K1/K2 system. If the system Changing Batteries alarms when walking in between the transmitter and receiver that means the installation is successful and the sensors are functional. 5. Do not install the sensors at the following locations: You can check the battery status via the app. - Página 5 że wymienione poniżej produkty: Hoofddorp, 2018-09-20 Model: BM-20 Multi-Beam IR Sensors Modell: BM-20 Mehrstrahl-IR-Sensoren Modèle : Capteur IR multifaisceau BM-20 Model: BM-20 IR-sensors met meerdere bundels Modelo: Sensores IR multihaz BM-20 Modelo: Sensores IV de múltiplos feixes BM-20 Modello: Sensori IR multiraggio BM-20 Model: Wielowiązkowe czujniki...
- Página 6 INFORMATION FOR THE USERS At the end of its life, the device has to be separated from the other waste. Consign the device and all its components together to a center of electronical and electrotechnical waste recycling center, designated by your local authorities. INFORMATIONEN FUR DIE BENUTZER Das Gerat am Ende seiner Lebensdauer von den anderen Abfallen getrennt werden muss.