Publicidad
EN
Settings
Remove the upper installation caps (marked UP) and waterproof
rubber plugs on both the transmitter and the receiver, pull out
both circuit boards (marked UP) gently and insert the batteries
(pay attention to the "+" "-" polarity).
Power Output Setting
This setting is in the transmitter unit only.
The distance between the transmitter and receiver is suggested
to be less than 6 meters and the default power out setting is high
output. If the distance is less than 3 meters, you could adjust the
power out setting by sliding switch 1 down.
Factory default
High output setting
Low output setting
Pairing to the K1/K2 Hub
The sensors need to be paired to the K1/K2 Hub first before use. To
pair the sensors, please refer to the smanos home app accessories
page, press the "+" button on the top right corner to add a new
accessory and follow the in-app instructions.
Once the sensors are added, you can check its status (the
connection with the K1/K2 Hub and battery status) on the
accessories page. You can customize your sensor by renaming,
selecting a location category in the IR beam sensors page of the
smanos home app.
You can select an alarm zone for your sensor by enabling Alarm
When Home Armed, Alarm Regardless of State (24/7) or setting
Alarm Delay Time. You may also adjust Alarm Time Settings (how
long the sensor alerts when it's triggered).
EN
Publicidad
