Step 3. Connect The Cooktop To Gas Supply - Samsung NA24T4230FS Manual De Instalación

Ocultar thumbs Ver también para NA24T4230FS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Correct installation
Hold down
bracket holes
Front of unit
Hold Down Bracket Installation
Step 2-2. Hold down bracket install guide
(A) SEALING STRIP
Side wall of
undercounter
cabinet
(C) SCREW
(B) BRACKET
4. With bottom side first, gently put the
cooktop down.
• Make sure the front of the
countertop is parallel to the cooktop.
• Make final check that all required
clearances are met.
5. Secure the cooktop to the countertop
using the provided hold-down
brackets as shown.
1.
Place the Bracket(B)over the holes
that match the size of the screws.
There are one set of screw holes in
each corner of the hob(H). Slightly
tighten a screw(C) through the
bracket(B) so that the bracket is
attached to the hob, but so that you
can still adjust the position .
2.
Carefully turn the hob back over and
then gently lower it into the aperture
hole that you have cut out.
H
H
H
H

Step 3. Connect the cooktop to gas supply

Shut off the main gas supply valve before disconnecting the old cooktop and leave
it off until the new hookup has been completed. Don't forget to relight the burner
on other gas appliances when you turn the gas back on.
Because hard piping restricts movement of the cooktop, the use of a CSA
International-certified flexible metal appliance connector is recommended unless
local codes require a hard-piped connection.
WARNING
If the information in this manual is not followed exactly, a fire or explosion may
result, causing death, personal injury, or property damage.
– Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
• DO NOT light a match, candle, or cigarette.
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch.
• DO NOT use any phone in your building.
• Clear the room, building, or area of all occupants.
3.
On the underneath of the hob, adjust
the brackets into a position that is
suitable for your worktop.
Then fully tighten the screws(C) to
secure the hob into position.
English 15

Publicidad

Tabla de contenido
loading

Tabla de contenido