Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off before
attempting to perform inspection or maintenance.
After use (Fig. 29)
When charging or storing the cleaner, hang it from a nail
using the convenient hanger in back by raising it.
Cleaning (Fig. 30 & 31)
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper pack
mounting area and the dust stopper.
CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Wash the dust bag in soapy water when it is clogged with
dust and the cleaner power becomes small. Dry it out
thoroughly before use. An insufficiently dried bag may
cause poor suction and shorten the service life of the
motor.
NOTE:
• Paper pack is a throw-away type.
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Removing and installing the sponge filter
(Fig. 32, 33 & 34)
To remove the sponge filter, remove the dust bag or
paper pack and then pinch and take it out.
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/paper pack mounting
area.
CAUTION:
• After cleaning sponge filter, be sure to install it on the
cleaner. If washed in water, dry it up before installing.
An insufficiently dried sponge filter may shorten the
service life of the motor.
Disposing cleaner
A Ni-Cd battery is built into this cleaner. Always remove it
before disposing of the cleaner.
10
Removing built-in battery
CAUTION:
• Never remove the built-in battery from the cleaner
except when disposing of the cleaner. The battery will
be damaged or a battery short-circuit could result.
• Do not touch the terminals with any conductive
material.
• Avoid storing battery unit in a container with other
metal objects such as nails, coins, etc.
• Do not expose battery unit to water or rain.
• Do not disassemble or alter battery unit.
1.
To remove the rear cover, push it in the direction of
the arrow. (Fig. 35)
2.
Withdraw the built-in battery halfway. (Fig. 36)
3.
Disconnect the three lead wires from the battery by
pressing the connector on the part 25 in the
direction of arrow shown in the figure and pulling
them. Then withdraw the battery unit completely.
4.
Put the removed battery unit in a plastic bag so that
it is not circuit-shorted. (Fig. 37)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Extension wand (Straight pipe)
• Nozzle
• Corner nozzle
• Dust bag
• Paper pack
• Dust stopper
• Charger DC7021
Publicidad
