Troubleshooting; Dc Power Port - Wagan Tech iOnBoost V8 Manual De Usuario

iOnBoost™ V8 by Wagan Tech
12. Disconnect the jumper cable assembly from the unit.
13. When convenient, using either AC or DC charging adapter, completely charge the
iOnBoost battery.
14. Store the unit and charge adapters in a cool, dry environment, away from flammable
materials. Remember to fully charge the unit every three months.

TROUBLESHOOTING

Jumpstart Warning Lights
The iOnBoost is ready to jumpstart when the cables are connected and a steady green light
illuminates on the cable safety block. The following chart displays the combinations of warning
lights that occur when the iOnBoost fails to display the ready light:
Warning lights Type of warning
Flashing red No vehicle battery
and green detected
lights
Solid red and 30-second timer
green lights has expired.
Flashing red Short-circuit or
light with reverse polarity
beeping sound
No lights Overload or
overheat

DC POWER PORT

For proper and safe operation of the DC power accessory outlet, do not place anything into it
except the plug of the accessory to be used.
Overloading the port may result in "tripping" a self-resetting circuit breaker. Removing the
overload automatically restores power to the DC Power Port.
1. Insert the DC connection cable into the DC output port.
2. Select the appropriate connection head and attach to the other end of the cable.
3. Set master switch to the "I" position.
4. Using the MODE button, press (not hold) to select the voltage your device requires. Do not
connect to device until proper output voltage is set.
5. Connect DC cable to the device you wish to charge.
6. After use, turn off the master switch ("O" position).
7. Recharge the iOnBoost as soon as convenient.
10
All manuals and user guides at all-guides.com
®
Solution
Cables are not properly connected or iOnBoost charge
is too low for jumpstarting. Check cable connection.
Check terminals for corrosion.
Check battery status indicator light on iOnboost,
recharge iOnBoost if needed.
Disconnect iOnBoost and follow connection procedure
again.
Disconnect immediately and follow connection
procedure again.
Allow unit to cool for 10 minutes. Plug into AC charger
to reset iOnBoost.
www.wagan.com