HAMPTON BAY Umber Manual Del Propietário página 11

3. Secure the light kit assembly to the switch
cup using the three screws that were re-
moved in step 1.
4. Remove the rubber washer, hex nut, bot-
tom cover and the finial from the threaded
nipple of the light kit assembly (Figure 17).
Bulbs
Threaded
Nipple
Rubber
Washer
Finial
5. With power off, install the two bulbs (Max.
14W, included) by screwing into the light
bulb sockets.
6. Position the glass shade over the thread-
ed nipple and pass the pull chain for fan
through pull chain guide on the side of the
light kit assembly.
7. Re-install the rubber washer, hex nut and
bottom cover to the threaded nipple to se-
cure the glass shade properly.
DO NOT OVER TIGHTEN THE HEX NUT,
OVERTIGHTENING THE HEX NUT MAY
CAUSE THE GLASS TO BREAK.
8. Re-install finial and finger tighten the finial.
Fan Without Light Kit
CAUTION - To reduce the risk of electric
shock, disconnect the electrical supply circuit
to the fan before installing the light kit as-
sembly.
1. In order to use the fan without the light kit,
remove the switch cup cover from the top of
the light kit assembly by removing the cen-
ter hex nut, and then thread the switch cup
cover off the threaded nipple on the top of
Hex Nut
the light kit assembly.
Bottom Cover
2. Remove the three screws from the switch
cup cover (Figure 18).
Figure 17
Holes (3)
Plastic Plug
3. Press the plastic plug (provided) into the
center hole of the switch cup cover.
4. Secure the switch cup cover to the switch
cup using the three screws that were re-
moved in step 2.
Serrated Head
Screw (3)
Figure 18
9.