Tools Required; Mounting Options; Installing Your Fan 3 - HAMPTON BAY Umber Manual Del Propietário

Tools Required

Phillips screw driver, straight slot screw
driver, adjustable wrench, step ladder, and
wire cutters.

Mounting Options

If there isn't an existing outlet box, then read
the following instructions. Disconnect the
power by removing fuses or turning off
circuit breakers.
Secure the outlet box directly to the building struc-
ture. Use appropriate fasteners and building
materials. The outlet box and support struc-
ture must be securely mounted and capable of
reliably supporting 35 lbs. (15.9kg). Use only
UL Listed outlet boxes marked "Acceptable
for Fan Support of 35 lbs. (15.9kg) or less."
Do not use plastic outlet boxes.
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PERSONAL INJURY, MOUNT TO
OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT OF 35LBS. (15.9KG) OR LESS",
AND USE SCREWS PROVIDED WITH THE OUT-
LET BOX. OUTLET BOXES COMMONLY USED
FOR THE SUPPORT OF LIGHTING FIXTURES
MAY NOT BE ACCEPTABLE FOR FAN SUPPORT
AND MAY NEED TO BE REPLACED. CONSULT A
LICENSED ELECTRICIAN IF IN DOUBT.
Figures 1, 2, and 3 are examples of different
ways to mount the outlet box.
Note: You may need a longer downrod to
maintain proper blade clearance when install-
ing on a steep, sloped ceiling. The maximum
angle allowable is 30˚. If the canopy touches
downrod, remove the decorative canopy
bottom cover and turn the canopy 180˚ before
Figure 1
attaching the canopy to the mounting plate.
To hang your fan where there is an existing
fixture but no ceiling joist, you may need an
Figure 2
installation hanger bar as shown in Figure 4
(available at your Hampton Bay retailer).

Installing Your Fan 3.

Figure 3
Figure 4