Checking The Charge Status Of The Battery; Used Batteries; Assembly; Installing/Changing The Blade - Grizzly AAS 108 Lion Traducción Del Manual De Instrucciones Original

GB
3. Plug the charger's power adapt-
er (15) into an electrical outlet.
The charge indicator will illumi-
nate on the charging cable con-
nector (14):
Red:
charged up
Green: the charging process
has finished.
The recommended charging
time is approx. 3 hours.
4. After charging, first remove the
mains plug of the charging de-
vice (15) from the socket and
then remove the charging cable
connector (14) from the charging
socket (12) of the device.
Checking the charge status of
the battery
The battery indicator (
displays the battery charge level (
1. Press the test button (6).
2. The charge status of the battery
( 11) will be shown:
Red-yellow-green:
battery fully charged
Red-yellow:
battery approx. half charged
Red: battery needs to be
charged

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
82
the device is being
5) on the device
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Assembly

Only insert the rechargeable
battery when the device is com-
pletely assembled. If the device
is switched on accidentally,
there is a danger of injury.
Always wear protective gloves
when handling the saw blade in
order to avoid cutting yourself.

Installing/changing the blade

Caution, risk of Injury!
- Do not use any blunt or bent
11).
- Always insert a suitable saw
An overview of appropriate blades
can be found in "Spare Parts/Ac-
cessories".
1. Turn the quick-change chuck (3)
2. To lock, turn the chuck ring (3)
3. Check that the saw blade is se-
blades or blades which are
damaged in any other way.
blade.
Installing the blade:
in the direction of the arrow
and insert the shank of the saw
blade (1) all the way into the slot
of the saw blade holder (16).
The teeth of the saw blade must
point downwards.
back to the starting position.
cure by pulling on it.