Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the saw blade:
4. Turn the chuck ring (3) in the
direction of the arrow
pull the blade out of the saw
blade holder (16).
Inserting/removing the branch
support
Inserting the branch support
1. Slide the branch support (13)
over the foot plate (2). The
brass washers (13b) on the
branch support (13) fit into the
indentations (2a) on the foot
plate (2).
2. Fold down the lock lever (13a)
of the branch support (13). It will
lock into place.
Removing the branch support
3. Fold the lock lever (13a) up-
wards and pull the branch sup-
port from the foot plate.
Operation
Switching on and off
Switching on:
1. Ensure that the battery (11) is
inserted (see „Removing/insert-
ing the battery").
2. Press the switch lock (7) and
the on/off switch (8).
3. You can progressively control
the stroke rate by using the on/
off switch (8).
Gentle pressure: low stroke
rate.
Greater pressure:
higher stroke rate.
The on/off switch cannot be
locked.
4. Release the on/off switch (8).
and
General working instructions
Wear gloves when handling the
saw blade. In this way, you avoid
injury from cuts.
Caution: Risk of injury and dam-
age to property!
- Do not use any blunt or bent
- Before sawing the work piece,
- Always insert a suitable saw
- Secure the work piece with the
- Apply only as much pressure as
- Switch the device off immedi-
- Always stand to the side of the
- Always make sure that the work-
- Avoid over-stressing the device
Switching off:
blades or blades which are dam-
aged in any other way.
check for hidden foreign objects
such as nails, screws. These
must be removed.
blade.
aid of clamping devices on the
workbench.
is required for sawing. If there is
excessive pressure, the sawing
blade may bend and break.
ately if the sawing blade jams.
Spread the saw cut out and pull
the blade out carefully.
saw when working.
place is well ventilated.
while working.
GB
83
Publicidad
Capítulos
Tabla de contenido
