Use Of; Start-Up And Start Cycle; Adjustments During Use; Change Tool - Femi job Line DP 12-942 PRO DISPLAY Manual Del Usuario

9. Use of

REQUIRED PPE

9.1. Start-up and start cycle

1. Press the ON start button.

9.2. Adjustments during use

9.2.1.

Change tool

1. Before starting the chuck, open the front
protection door.
In the case of a chuck with a rack:
In the case of a self-locking chuck:
2. Make sure that the drill press is centred in
the chuck. Tighten the bit sufficiently so that
it doesn't slip while drilling.
28 ▪ English
9.2.2.

Drilling depth adjustment

Press locknut (A) and slide it vertically until the
desired height.
Visually check the height selected on the metric
ruler (B).
A
B
9.2.3.

Rotation speed adjustment

IMPORTANT!
recommended speed for the bit
you are using and for the material
to be drill.
The chuck of this drill press can turn at different
speed levels: from 390 to 2200 rpm.
1. Move lever (A) to change the drilling speed.
2. Read the set speed on the display (B).
A
B
DP 12-942 / DP 12-954 (PRO DISPLAY)
Use the