Saw Chain Tension Adjustment - Remington WIZARD Manual De Instrucciones

ASSEMBLY
Continued
3. Feed chain into groove of bar and slide bar away
from the motor to remove slack from chain.
4. Replace Belleville washer. IMPORTANT: The ser-
rated edge of the Belleville washer must be in con-
tact with the guide bar as shown in Figure 3.
Serrated Edge
Against Guide Bar
Figure 3 - Belleville Washer Assembly
5. Replace sprocket cover (see Figure 1, page 3).
6. Replace guide bar nut on guide bar bolt and finger
tighten (see Figure 1, page 3).
7. See Saw Chain Tension Adjustment to properly ten-
sion saw chain.
SAW CHAIN TENSION
ADJUSTMENT
WARNING: Unplug Pole Saw from power
source before adjusting saw chain tension.
WARNING: Cutting edges on chain are
sharp. Use protective gloves when han-
dling chain.
www.desatech.com
4
Guide Bar
Belleville
Washer
113041