Maintenance Instructions - Remington WIZARD Manual De Instrucciones

SAW CHAIN TENSION
ADJUSTMENT
Continued
3. Pull chain away from the bottom of the bar approxi-
mately 1/8 inch (links should not come out of guide
bar groove) and let go. The chain should return to
rest against the guide bar rail (see Figure 5).
4. Make sure chain moves freely around guide bar then
tighten guide bar nut.
5. After chain tension is correct, tighten guide bar nut
firmly. If not, guide bar will move and loosen chain
tension. This will increase the risk of kickback. This
can also damage Pole Saw.
Guide Bar Nut
Figure 5 - Correct Chain Tension
MAINTENANCE
INSTRUCTIONS
1. Check and readjust chain periodically during life
of the chain.
2. Always check and adjust chain when cool, not hot.
3. With each use of the Pole Saw apply a small amount
of lubricating oil directly to the saw chain (We rec-
ommend using SAE #30 motor oil for lubrication
and rust prevention).
4. Check and sharpen chain frequently. See owner's
manual for sharpening procedure.
www.desatech.com
Guide Bar
Gap
Incorrect
Tension
6
Guide Bar
Correct
Tension
113041