Initial Operation; Swivelling Out The Blade Beam - Parkside PHSL 900 A3 Traducción Del Manual De Instrucciones Original

GB IE
Assembly of the middle
B
tubular shaft (9) (optional):
The long-shaft hedge trimmer can
be used optionally with or without
the middle tubular shaft (9).
2. Remove the cap (23) from the middle
tubular shaft (9).
Loosen the star wheel (11).
Slide the middle tubular shaft (9) onto
the tubular shaft on the appliance hous-
ing (12) in a slight rotating movement.
When doing so, the retaining knob
(10) locks into place. Fix the two tubu-
lar elements in place with the rotary
knob (11).
Only tighten the rotary knob
(11) by hand! The use of
maximum manual force will
damage the tubular shaft.
Assembly of the front tubular
B
shaft (6):
3. Remove the cap (23) on the front tu-
bular shaft (6). Loosen the star wheel
(8/11). Slide the front tubular shaft (6)
optionally onto the middle tubular shaft
(9) or onto the tubular shaft (12) on the
appliance housing in a slight rotating
movement. The safety button (7) locks
into place. Fix the two tubular elements
in place with the rotary knob (8/11).
Only tighten the rotary knob
(8/11) by hand! The use of
maximum manual force will
damage the tubular shaft.
4. Place the round handle (13) onto
C
the tubular shaft of the device hou-
sing (12). Fold on the counter-holder
(24) of the round handle and screw
30
it on together with the large washer
(25) and the rotary knob (26).
The dismantling takes place in reverse
order.

Initial Operation

Do not use the equipment
without the hand guard.
Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment is
functional before each use.
The On/Off switch and the
safety switch must not be
held closed. They must switch
off the motor when on is re-
leased. Should a switch be
damaged, stop working with
the equipment. Ensure that the
mains voltage value matches
the label on the equipment.
Note noise protection and local
specifications. The use of the equip-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
Swivelling Out the
D
Blade Beam
1. Hold the safety blade beam (1) on the
handle to adjust the blade beam (5).
2. Unlock the safety lever (3) and keep it
pressed.
3. By simultaneously exerting pressure on
the lock lever (4), you will loosen the
fixation of the cutter bar (1).