Wall Bracket; Storage; Transport; Waste Disposal And Environmental Protection - Parkside PHSL 900 A3 Traducción Del Manual De Instrucciones Original

GB IE
damp cloth or a brush to do this. Do
not wash down the equipment with
water, or submerge it in water.
• Do not use any cleaning agents or sol-
vents. These could cause irreparable
damage to the equipment. Chemical
substances can attack the plastic parts
of the equipment.
• Clean the cutter bar carefully after
each use. Wipe it off
with an oily cloth or
spray it with a metal
protective spray.
• Keep the hedge trim-
mer dry and covered with the blade
protection supplied and out of reach of
children.
• The gears is maintenance free

Wall bracket

You can hang the motor part on the wall
with the keyhole bore (29) on the bottom
of the device.
• Using dowels, place one screw at the
desired position on a wall.
• The screw head can have a diameter
of 7 - 10 mm.
• Leave the screw head protruding at a di-
stance of approx. 10 mm from the wall.
• You can place the device onto the
screw using the opening on the bottom
and pull the device down until it stops.
When drilling, be careful not
to damage any supply lines.
Use suitable search devices
to find these or consult an in-
stallation plan for guidance.
Contact with electrical cables
can lead to electric shock and
fire. Contact with a gas pipe
can result in an explosion.
34
Damage to a water pipe can
lead to property damage and
electric shock.

Storage

• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children. Store the appliance
in horizontal position or secured
against toppling over.
• Hang up the advice on the handle for
adjusting the blade beam (5) for stor-
age.

Transport

never transport your appli-
ance while the appliance is
turned on! Risk of injury!
• For transport, always use the blade
guard (21).
• Always carry the appliance with both
hands, with one hand on the back
handle and the other hand on the front
round handle (13).
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Electrical machines do not belong
in domestic waste.
Take the equipment to a waste disposal
site. The plastic and metal parts that are
used can be separated out into pure
grade, which allows recycling.
Ask our Service Centre for details.