Suzuki 99000-990D2-220 Instrucciones De Montaje página 12

12/12
19.Temporarily fix the the power
source harness, switch harness
and RH LED lamp harness of
the Relay harness set 2 to the
STD harness by using the
Clamp 6 in the back of the
radiator as shown in the picture.
20.Swing the handlebar left and right, and be sure that each harness
isn't stretched or it doesn't interfere the vehicle. If the harness inter-
feres the vehicle, fix the harness to eliminate the interference by
using the spare Clamp 6.
21.Tighten all Clamp 6 firmly, and cut the excess part of the Clamp 6
by using cutting plier.
22.Reinstall all parts of the bike which were removed.
(Refer to the DL1050RQ/RC service manual.)
23.Adjust the optical axis.
How to adjust the optical axis
4/5 height from the ground to
the center of LED fog lamp
GENUINE SUZUKI ACCESSORIES
LED fog lamp
Main optical axis
4/5 height from the ground
to the center of LED fog
lamp
3m
FWD
Brightest point (Main optical axis)
Measure the height from
the ground to the center
of LED fog lamp