Publicidad
User's address related to the first button
To program the user's address related to the first button
it is sufficient to set micro-switches SW1 and SW2 (the
last present only on the CD4138PL) located on the back
of the digital encoder. Table 1 shows how to set micro-
switches SW to set the requested address.
Programming of starting user's address of buttons
and operating modes
To program the starting user's address of buttons and
the operating modes it is necessary that the digital
encoder is connected on the same riser on which it is
even connected one digital push-button panel TD4100PL
or digital door-keeper exchanger PDX4000; In the
case this is not true it is possible to connect temporarily,
just for the time of programming, one of the two
equipments joining only terminals +, - and DB.
CD4134PL
CD4138PL
Entering programming mode
To program the starting user's address of buttons and
the operating modes it is necessary to enter in the
programming mode just pulling-out jumper J1 in order
to free the two poles; digital encoder generates an
intermitting waiting tone.
Exit the programming mode
To exit programming mode insert again jumper J1 in
order to short-circuit the two poles.
Programming starting user's address
Enter the programming mode as described in the specific paragraph.
Dial on the keypad of TD4100PL or PDX4000 the address you wish
to program and send enter; an acknowledge tone will be heard.
Make other programming or exit the programming mode as described
in the specific paragraph.
In the case of sending more address only the last one is stored.
Important notes.
TD4100PL
Setting all the micros-witches of SW2 in OFF
position (all the triggers set down; code 0) the
system will not send the user's address related
to the first button (being 0). Besides, if are
present buttons connected to P1 and P2 they
will have the same user's address of 2
rd
3
button of the digital encoder.
Some examples of programming
J1
SW
0
+ 4
0
+ 12
0
+ 56
15
+ 4
15
+ 12
15
+ 56
100 + 0
100 + 32
150 + 36
699 + 4
micro-switching settings (see table 1)
address to send to the encoder during the programming phase
Table 2.
Operating modes
Operating mode
Timing of relay-ON
Enabling automatic connection of No
door station from internal station*
* enabling this function from any internal station it would be possible,
pressing button
to activate the lock release pressing again the button
nd
1
st
button
range of addresses
4
1 ÷ 63
12
1 ÷ 63
56
1 ÷ 63
19
16 ÷ 78
27
16 ÷ 78
71
16 ÷ 78
100
101 ÷ 163
132
101 ÷ 163
186
151 ÷ 213
703
700 ÷ 762
users' adresses which can be managed
by the encoder
user's address related to the first button from the top
Codes to dial
9990
3 sec. 6 sec. 3 sec. 6 sec.
, to communicate with the external station and
and
9991
9994
9995
No
Yes
Yes
.
12
Mi 2375
Publicidad
