Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2 PEDESTAL, 1 LEG ASSEMBLY
NOTE: Only for 96" top.
LEG ASSEMBLY
1.
Insert adjustable feet into leg and slide into place.
Make sure that three holes are showing near the
bottom of the leg. This will give your leg a height of
32⁄". (See Figure 3)
NOTE: If desired, insert locking tabs through
legs and adjustable feet to lock feet into place.
Figure 3
2. Align bracket to outside of each leg and secure
using two bolts, two lock washers and two nuts per
bracket. (See Figure 4)
NOTE: Do not tighten bolts.
NOTE: Brackets must be facing the same
direction.
Figure 4
PAGE 2 OF 18
WOOD OR LAMINATE TOP ASSEMBLY CONTINUED
Adjustable Feet
3 Holes
Lock
Washer
Leg
Bolt
Nut
Bracket
MOUNTING WOOD OR LAMINATE TOP TO LEG
1. Adjust pedestal leveling feet to allow installation of leg.
2. Slide leg underneath the center of the tabletop and
line up with pre-drilled holes. (See Figure 5)
Figure 5
3. Using twelve #14 x 3/4" hex head slotted wood
screws, attach leg to the underside of the top
through pre-drilled holes. (See Figure 6)
NOTE: Tabletop does not include pre-drilled
holes for inner part of leg bracket.
Figure 6
Tabletop
4. Adjust pedestal leveling feet again to align height
with center leg.
5. Tighten all bolts. Assembly is complete. (See Figure 7)
Figure 7
Completed Assembly
Pedestal Leveling Feet
Holes Not
Pre-drilled
Wood
Screw
Leg
1120 IH-2171
Publicidad
Tabla de contenido
