Foot Switch - ProMed 5040 SX Instrucciones De Empleo

o
PeratinG tHe unit
N. Safety
• The safety device (O) is located on the rear panel of the device.
• Unplug before changing the fuse from the mains.
• To replace the fuse, you must unscrew the fuse holder with the
screw driver and use fuse T 0,8A (for 115 volt version: T 1,6A).
O. Foot switch / rocker pedal (optional)
• A foot switch (ON/OFF) and also rocker pedal is available as an
accessory. They are either connected to the connector on the rear
panel of a device (P).
• As long as a foot switch or a rocker pedal is connected, the
button (B) has no function.
• If the rotation of the handpiece is deactivated by a micro-switch
(U) and any type of pedal is connected, a beep tone will be
heard when the foot pedal is pressed and a blue LED on button
(B) blinks in faster intervals, (2x short, so-called „double-
pulse blinking).
• The rotating direction can only be changed (clockwise/
counterclockwise) with the button (C)
pedal or foot switch is not pressed.

Foot switch

• With the foot switch (ON/OFF) the device can be activated
i.e. the adjusted values of the speed control and spray can be
triggered by pressing the foot button.
• The removal of the foot from the button leads to stop the speed of
the handpiece and spray.
Rocker Pedal
• With the rocker pedal the speed can be controlled variably and
vey delicately.
• The setting of the button (D)
„preselection" at maximum points.
• The standard possibility by foot is limited according to the shown
speed on the display (F).
• In order to direct the total speed range with the foot control,
adjust the speed with the button (D)
• By removing the foot from the pedal, the motor and the spray
flow stops.
when the connected
(Equivalent 40 000 rpm).
Note:
Only Promed foot pedals can be used.
and (E)
serves a
at the maximum level
DE
EN
FR
IT
ES
PT
PL