Jlr Doip Vci Connectors And Controls; Universal Serial Bus (Usb) Connection; Wireless Local Area Network (Wlan); Connection Xxx - Bosch JLR DOIP VCI Manual Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
en
8 | Jaguar Land Rover DoIP VCI | Product Description
4.3

JLR DOIP VCI Connectors and Controls

A number of standard connectors and controls are
available on the JLR DOIP VCI to facilitate operation
and communication with vehicles and workshop net-
works. These connectors and controls are shown in the
following illustrations.
1
2
5
3
4
6
Pos.
Description
1
TFT color display
2
Control buttons
3
USB port
4
WiFi Adapter
5
Ethernet port
6
Diagnostic connector
4.4
Universal Serial Bus (USB) connec-
tion
The JLR DOIP VCI has a fixed USB configuration
which cannot be changed. This makes sure that the
JLR DOIP VCI can always be connected to a single PC
running the Pathfinder Software so you can configure
LAN or WLAN settings required by your local network. In
addition, it is important to note that a USB connection
is required to configure, pair and update the firmware
on the JLR DOIP VCI.
|
1 689 989 309
2016-11-11
4.5

Wireless Local Area Network (WLAN)

connection xxx
The 802.11b/g/n WLAN connection on the
JLR DOIP VCI is set up and configured while the device
is connected and paired over USB to a PC running the
Pathfinder Software.
4.6

Additional JLR DOIP VCI Features

4.6.1

Diagnostic Connector and Cable

Communication between the JLR DOIP VCI and the
vehicle's electronic systems is through the 26-pin diag-
nostic connector cable.
4.6.2

Power Source

The JLR DOIP VCI is intended to be powered from the
vehicle battery via the diagnostic connector cable. The
JLR DOIP VCI may also be powered over USB using
your PC for a system update or only data transfer.
i
The JLR DOIP VCI must be powered via the USB
connection cable when you are configuring the
JLR DOIP VCI for wireless communication.
4.6.3

Light Emitting Diode (LED) Indicators

Four LEDs are located on the front of the JLR DOIP VCI.
The LED indicators provide the following status infor-
mation:
Symbol Color /
Function
Status
Off
Missing power supply
Green
Normal operation
Flash red
No Power from the DLC connector
Green
Communication to the vehicle is ok
Off
No communication to the PC Host
flash green
Communication to the PC Host is ok
Green
JLR DOIP VCI is running without errors
Red
Error (run Reset)
Robert Bosch GmbH

Publicidad

Tabla de contenido
loading

Tabla de contenido