Connection To The Water Supply; Flow Rates - TMC Pro Pond UV110 Advantage Instrucciones De Uso

MOUNTING ON A HORIZONTAL
SURFACE
This unit may be mounted on any suitable flat surface including your filter lid.
Caution: To prevent this unit falling into water, do not install it above or
alongside your pond. Do not make the electrical connection to your unit
until it has been plumbed in and fixed securely.
MOUNTING ON A WALL OR OTHER
VERTICAL SURFACE
This unit may be mounted on a wall or other suitable vertical surface.
When full of water the unit is too heavy to mount onto a conventional
wooden fence panel. The unit should be mounted on a wall as shown in the
diagram below and using the mounting kit provided.
Caution: To prevent this
unit falling into water, do
not install it above or
alongside your pond. Do
not make the electrical
connection to your unit
until it has been plumbed
in and fixed securely.
The mounting kit consists of six sets of screws, washers and rawlplugs. If
mounting onto brick use the rawlplugs. Identify the mounting plate at either end
of the unit. Assuming the unit is mounted as shown above, use the open slot in
the left hand mounting plate and the long centre slot in the right hand mounting
plate to register and fix the unit. Then mark the upper and lower slots on each
mounting plate. Use all six fixings to mount the unit, and ensure the washer is
fitted between the head of the screw and plastic mounting plate.

CONNECTION TO THE WATER SUPPLY

This unit has stepped inlet and outlet ports, allowing the use of either 2" or
63mm rigid BSP plastic pipe. If using 2" BSP plastic pipe the glued
connection will be made into the second stepped stage of the inlet and
outlet ports. If using 63mm rigid plastic pipe the connection will be made to
the first stepped stage of the inlet and outlet ports.
The unit may also be connected to flexible plumbing using the appropriate
plumbing fittings (not supplied). To ensure unrestricted flow, it is recommended
that the unit is not plumbed in with anything less than 1

FLOW RATES

Please note that, for optimum performance, we recommend that you pass
the entire volume of your pond through the UV unit approximately once
every two hours. Please also note that we suggest a minimum flow rate of
passing the pond volume through the unit once every three hours.
Unit
UV110
CONNECTION TO ELECTRICAL SUPPLY
Consult a qualified electrician.
Caution: Use in the area of the garden pond only if the installation complies
with the relevant wiring regulations.
Caution: Always disconnect all pond appliances from the mains electricity
supply before putting your hands into the water.
Caution: Power must be supplied through a Residual Current Device (RCD)
with a rated residual operating current not exceeding 30mA.
Important: This unit is designed to be permanently wired to the mains supply
using the three core 0.75mm
permanently connected to the mains supply inside a dry, weatherproof
enclosure and through a double pole switched fused spur with a minimum
contact gap of 3mm. The fused spur must only be fitted with a 3 amp fuse.
For safety never use a larger rated fuse.
This unit is fitted with 5 metres of power cable. To prevent the unit
inadvertently being dropped into the pond, we strongly recommend that it
is securely positioned at least 2 metres from the edge of the pond. Any
flexible cabling used between the unit and the permanent wiring should also be
kept to a minimum length. We recommend a maximum length of 1.5 metres.
Mains supply cable colour coding: Brown Live, Blue Neutral, Yellow/Green Earth.
INTERNAL FUSE REPLACEMENT
Always isolate unit from mains supply before undertaking any maintenance.
The control gear on this unit is fitted with a 5mm x 20mm 3.15 Amp quick
blow fuse. Only replace with the same type of fuse.
Maximum Flow Rate
8000 imp gal/36000 litres/9400 US gal per hour.
rubber cable fitted to the unit. This unit must be
2
2
"/50mm pipework.
1 /
2