Vaporesso LUXE PM40 Manual Del Usuario página 5

5. Power On/Off
Press the power button 5 times within 2 seconds to power on
or power off the device.
6. Lock/Unlock the system
Press the power button 3 times continuously to unlock the
system if the device is in the locked state. Without any
operation within 5 seconds, the system will lock automatically.
7. Adjust the output wattage
Press the power button gradually in the unlocked state to
adjust the output wattage.
To avoid overheating, set the device's output wattage only
within the recommended wattage output range specified for
the coil.
8.Adjust the airflow
Adjust the airflow toggle to customize your vaping experience.
9.Start vaping
In the locked state, hold the power button and inhale through
the drip tip. Release the power button and exhale.
10.Charge the device
Plug in the Type-C USB cable to charge the battery. The
battery level will displayed on the OLED screen. When it's fully
charged, the device will stop charging automatically.
PROTECTIONS
1) Short-circuit Protection: If a short circuit is detected during
vaping, the device will stop working and the current resistance
information will flash 5 times on the screen.
2) No Load Protection: If the coil can't be detected during
vaping, the device will stop working and the resistance
information will change to 9.99Ω and flash 5 times on the
screen.
3) Low Resistance Protection: If an ultra-low resistance is
detected during vaping, the device will stop working and the
current resistance information will flash 5 times on the screen.
4) High Resistance Protection: If an ultra-high resistance is
detected during vaping, the device will stop working and the
resistance information will change to 9.99Ω and flash 5 times
on the screen.
English
3