Installation - Zanussi ZRB936PW2 Manual De Instrucciones

Problem
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigeration is too high.
The temperature in the
freezer is too high.
The appliance does not op-
erate.
The lamp does not work.
If your appliance is still not working properly af-
ter making the above checks, contact the After
Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
3. Remove the lamp cover (2).
4. If needed replace the lamp with a light of
similar characteristic and power. It is sug-
gested to use Osram PARATHOM SPE-
CIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
24
All manuals and user guides at all-guides.com
Possible cause
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Products are too near to each other. Store products so that there is cold
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
operation of the appliance before installing the
appliance.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
air circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
1 2
stallation".
gaskets. Contact the Service Center.
Solution
www.zanussi.com