Troubleshooting - GGP ITALY MT48Li Manual De Instrucciones

7. TROUBLESHOOTING

Problem
String will not advance when using
the auto-feed head.
Grass wraps around shaft housing
and string heaD
Motor fails to start when switch
trigger is depressed.
Possible cause
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
Solution
Lubricate with silicone spray.
Install more string, refer to string
replacement earlier in this manual
Pull string while pressing line
release button.
Remove string from spool and
rewind. Refer to string replacement
earlier in this manual
Cut tall grass from the top down to
prevent wrapping
To secure the battery pack, make
sure the latch on bottom of the
battery pack snaps into place.
Charger the battery pack according
to the instructions included with
you model
Make sure lower shaft is fully
seated in shaft coupler on upper
shaft and secure shaft coupler.
8
EN