Chapter 3: 12 Pocket Multi-Unit Chargers - Motorola DLR Serie Manual Del Usuario

MN007800A01-AA

Chapter 3: 12 Pocket Multi-Unit Chargers

3 To charge a radio with battery, slide the radio into the charger pocket and align it to the groove
on each side of the radio with the corresponding raised rail on each side of the charger pocket.
NOTICE: Ensure complete contact between the charger and radio contacts.
4 To charge a stand-alone battery, the followings are steps to insert the battery into the charger
pocket.
1 Align the raised tab on each side of the battery with the corresponding groove on each side
of the charger pocket.
2 Press the battery towards the rear of the pocket.
3 Slide the battery into the charger pocket, ensuring complete contact between the charger and
battery contacts.
When the radio or stand-alone battery is properly inserted into the charger pocket, the charger
indicates the battery level status as shown in
The charger indicator illuminates in Steady Red to indicate the radio or stand-alone battery is
charging rapidly. When the battery is nearly or fully charged, charger indicator changes to
Steady Green.
5 To remove a radio or stand-alone battery from the charger, use both hands to remove a radio or
battery from the charger pocket. One hand to hold and support the charger while the other hand
removes the radio or battery.
Figure 3: Multi-Unit Charger
2
1
8
1
2
3
12
Table 6: Charger LED Indicator on page
3
7
Radio Contacts
Pocket 1
Battery Contacts
15.
4
5
6