Publicidad
Idiomas disponibles
Idiomas disponibles
1. Make leakage solution by mixing 1 part liquid dish soap
and 3 parts water.
2. With the cylinder connected to the hose, spoon or brush
several drops (or use squirt bottle) of the solution onto the
connections along the hose, regulator and cylinder
(Fig. 13).
3. Open the propane cylinder valve. Inspect the connections
and look for bubbles.
4. If no bubbles appear, the connection is safe. If bubbles
appear, there is leakage. Loosen and re-tighten this
connection. If there is still a leak, turn off the cylinder
and contact the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563).
At least once a year, a complete inspection of the entire gas
path components should be performed by a professional
technician.
Operation
m
WARNING!
Do not attempt to operate the heater
until you have read and understand all precautions in this
manual. Make sure all assembly is complete and leakage test
have been performed. Failure to do so can result in death,
serious personal injury, or property damage.
Before Turning on the Gas Supply
1. The heater is designed and approved for OUTDOOR USE
ONLY. DO NOT use it inside a building, garage, or any
other enclosed area.
2. Make sure the surrounding areas are free of combustible
materials, gasoline, and other flammable vapors or liquids.
3. Ensure that there is no obstruction of air ventilation.
Ensure all gas connections are tight and there's no leak.
4. Be sure any component removed during assembly or
servicing is replaced and fastened prior to starting.
Fig. 13
+ Sun Joe
customer service
®
®
Lighting the Heater
m
WARNING!
• Heater should be thoroughly inspected before each use,
and by a qualified service person at least annually. If
relighting a hot heater, always wait at least 5 minutes.
• Before lighting, inspect the hose assembly for evidence of
excessive abrasion, cuts, or wear. Suspected areas should
be leak tested. If the hose leaks, it must be replaced prior
to operation. Only use the replacement hose assembly
specified by manufacturer.
m
WARNING!
Follow the instruction below to light
the heater. Improper lighting operation may cause personal
injury or property damage.
1. Connect the propane cylinder and perform the leakage
test as instructed above.
2. Make sure the lighting knob is in the OFF position
(pointing to the black dot). Open the propane cylinder
valve.
3. Push in the lighting knob and turn it counterclockwise to
the LOW position (pointing to the small red dot). This will
light the burner. If needed, keep depressing and turning
the lighting knob counterclockwise until the burner is lit.
You will hear one click when the burner is lit (Fig. 14).
Fig. 14
Lighting knob
4. Once the burner is lit, keep the knob depressed for 30
seconds. Then release the lighting knob.
5. If burner does not stay lit, repeat steps 3 and 4 after 5
minutes.
6. If burner still does not stay lit, then:
i. Push in the lighting knob and turn it counterclockwise to
the "LOW" position.
ii. Keep depressing the lighting knob, use a long stem
lighter to light the burner through the ignition hole on
the emitter screen (Fig. 15).
8
OFF
LOW
HIGH
Publicidad
