Trust SMART Home AYCT-102 Manual Del Usuario página 4

EN
AYCT-102 REMOTE CONTROL
1. Channel switch
Slide the channel switch to I, II, III or IV to access 16
1 2 3 4
different channels (4 x
2. Control 1 Trust Smart Home receiver per
channel
To control receivers individually, assign a seperate channel
1 2 3 4
( and ) to each receiver. Read the receivers
manual for the code learning procedure.
3. Control multiple Trust Smart Home receivers
per channel
To control several receivers simultaniously, assign the
1
same channel (for example
the receivers manual for the code learning procedure.
4. Group function
G
Assign the button to multiple receivers to switch a
group of receivers ON/OFF simultaniously (no dimming).
Read the receivers manual for the code learning
G
procedure. The button can always be used, regardless
of the channel switch setting (I, II, III or IV).
5. Manual operation of a Trust Smart Home on/
off receiver
A
Press ON to switch the receiver on.
B
Press OFF to switch the receiver off.
4
).
) to those receivers. Read
6. Manual operation and dimming with a Trust
Smart Home transmitter
A
Press ON once to switch the receiver on.
B
Press ON again to activate the dim-mode. The light will
slowly dim up and down.
C
Press ON a third time to set the desired light intensity.
D
Press OFF to switch the receiver off.
The receiver will return to the last light level when
switched on again.
7. Manual operation of a Trust Smart Home
receiver for electric screens
A
Send an ON-signal to raise the screen.
B
Send an ON-signal again to stop.
C
Send an OFF-signal to lower the screen.
D
Send an OFF-signal again to stop.
Read the receivers manual to reverse the direction of the
screen, if needed.
8. Replace transmitter battery
A
Open the battery compartment by screwing it open.
B
Place a new 3V CR2032 lithium battery. The polarity
should match the symbols on the holder.
C
Close the battery compartment.