Metra 70-1720T Instrucciones De Instalación

Installation Instructions for 70-1720T
Keyless Entry Retention
• Incorporates the factory keyless-entry security
system into the aftermarket installation
HARNESS COMPONENTS
• A) Wiring harness
TOOLS REQUIRED
• Phillips screwdriver • 8mm socket wrench
CAUTION!
All accessories, switches, climate controls panels, and especially air bag
indicator lights must be connected before cycling the ignition. Also, do not remove the
factory radio with the key in the on position, or while the vehicle is running.
Remove (2) Phillips screws from the bottom edge of the glove box
1.
door, and then remove the door.
Remove (3) Phillips screws from
2.
the lower steering column panel.
Remove (2) Phillips screws
3.
under the climate control panel.
Remove (4) Phillips screws from
4.
the lower dash location.
Remove (2) 8mm screws securing
5.
the rear of the radio, and then remove and unplug the radio.
1. Remove the (2) Phillips screws securing
the rear support bracket to the back of the
factory radio, and then remove. (Figure A)
2. Re-route the factory wiring harness behind
the lower console and plug the female
end of the Metra harness into the factory
harness. Plug the green security plug into
position "A", and then plug the male end
of the Metra harness into position "B" in
the back of the factory radio. (Figure A)
3. Carefully slide the factory radio
between the metal support brackets
and place the radio behind the lower
dash. (Figure B)
Note: The face of the radio should
point up.
4. Test the radio and keyless entry for proper operation. Using the
instructions found in the 99-7891 or 89-30-7891, secure the
assembly to the sub-dash.
®
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Honda Civic 1996-1998
HARNESS FEATURES
Disassembly
Kit Assembly
- The World's best kits.
®
(Figure A)
(Figure B)
• metraonline.com
™
REV. 4/10/17