Nilox FOOLISH Manual De Instrucciones página 38

Record
Shutter-Stop
Pausa
Please follow the steps below to code the remote control before use to realize the correspondence of remote control
and FOOLISH :
Turn off FOOLISH , press and hold "Record" key, turn the power switch to "ON", and then release "Record" key. To
1.
conclude the process of synchronization (hold "Record" of FOOLISH) press the "Stop" and "Record" button once for
3 seconds. After successfully synchronized the remote control, you will hear a double beep.
Note:
a. Use wireless remote control to control FOOLISH can check whether the code pairing is successful. The control
functions include: Video recording starting/stopping, photo shooting, waking in standby mode, and laser light turning
on/off; FOOLISH will tick once for each operation. In case of video recording stopping or laser light turning off,
FOOLISH will tick twice;
b. Remote control range: Remote control within 1 5 meters in anyangle horizontally without barriers
c. To press "Record", "Shutter" or "Stop" key on the remote control in standby mode can wake up the system
8. Standby mode:
A. Non-voice control standby:
Push the VOX switch to "OFF" and turn the power switch to "ON", the system will start working and it will enter preview
state after finishing initialization. In case of no any mission and operation, the system will auto enter standby power-saving
mode at the end of the auto standby time set. Press "Record" or "Shutter" key at this time, or remote control any key on
the remote control, the system will be waked up.
Note:
a To press keys on TFT screen in standby mode cannot wake up the system;
b The LCD segment screen does not display anything in standby mode.
B. Voice control Standby:
Push the VOX switch to "ON" and turn the power switch to "ON", the system will start working and it will enter preview
state after finishing initialization. In case of no any mission and operation, and the environmental voice is lower than 65dB
continuously, the system will auto enter standby power-saving mode at the end of the auto standby time set. Press
"Record" or "Shutter" key at this time, or remote control any key on the remote control, the system will be waked up.
When the environmental voice is higher than 65dB, the system will wake up and enter video recording state.
Note:
a To press keys on TFT screen in standby mode cannot wake up the system;
b The LCD segment screen does not display anything in standby mode.
long press "Shutter" key for 3 s can
turn on and turn off the laser
function
~ 15 ~