Spare Parts - Tools; Rechargeable Battery Pack; Protecting The Environment - Stanley PB2500 Smart Manual De Instrucciones

E N G L I S H
•
Apply grease to the inside of the jaw guide (P) where the jaws (Q) make contact. A Molybdenum Disulfide
based grease is recommended.
•
Mount the spring (S)
•
Mount the jaw pusher(R) and the jaws (Q)
•
Press front clutch (U) and tighten the jaw guide (P). Release front clutch (U).
•
Mount the nose housing (B). Tighten the nose housing nut (C).
•
Perform tool reset function to ensure the tool is at the initial home position as described in section 5.2
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
DO NOT use water or any cleaning solutions.
6.3 SPARE PARTS – TOOLS
For spare parts we refer you to the specific service manuals which you can find on our website at
http:// www.stanleyengineeredfastening.com/resource-center/document-library
6.4

RECHARGEABLE BATTERY PACK

This long life battery pack must be recharged when it fails to produce sufficient power on jobs which were
easily done before. At the end of its technical life, discard it with due care for our environment:
Run the battery pack down completely, then remove it from the tool.
Li-Ion cells are recyclable. Take them to your dealer or a local recycling station. The collected battery packs will
be recycled or disposed of properly.
6.5

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be disposed of with normal household waste.
Should you find one day that your STANLEY Engineered Fastening product needs replacement, or if it
is of no further use to you, do not dispose of it with household waste. Make this product available for
separate collection. Separate collection of used products and packaging allows materials to be recycled
and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection of electrical products from the household, at
municipal waste sites or by the retailer when you purchase a new product.
You can check the location of your nearest authorised repair agent by contacting your local STANLEY
Engineered Fastening office at the address indicated in this manual. Alternatively, a list of authorised
STANLEY Engineered Fastening repair agents and full details of our after-sales service and contacts are
available on the Internet at: www.StanleyEngineeredFastening.com
18