Tool Operation - Stanley Bostitch MCN150-E Manual De Instrucciones

SAFETY INSTRUCTIONS
m IMPORTANT READ CAREFULLY: It is important that all operators read and understand all sections
of this Tool Technical Data manual and the separate Safety and Operating Instruction Manual which
come with this tool. Failure to do so could result in you or others in the working area to be seriously injured.
m WARNING! Eye protection in accordance with 89/686/EEC, and with equal or greater grade than defined
in EN166 should be used. However all aspects of operators work, environment and other type/s of machinery
being used, should also be considered when selecting any personal protection equipment.
Note: Non-side shielded spectacles and face shields alone do not provide adequate protection.
m WARNING! To prevent accidental injuries:
•
Never place a hand or any other part of the body in fastener discharge area of tool.
•
Never point tool at yourself or anyone whether it contains fasteners or not.
•
Never engage in horseplay.
•
Never pull the trigger unless the nose is directed towards the work.
•
Always handle the tool with care.
•
This tool is intended to be used for fastening metal connecting plates to wood in construction applications. DO
NOT USE for fastening harder materials which could cause buckling of the fasteners and damage to the tool. If
you are unsure of the suitability of this tool for certain applications, please contact your local sales office.
•
Do not pull the trigger or depress the trip mechanism whilst loading the tool.
•
To prevent accidental actuation and possible injury, always disconnect air supply:
1. Before making adjustments. 2. When servicing the tool. 3. When clearing a jam. 4. When tool is not in use.
5. When moving to a different work area, as accidental actuation may occur, possibly causing injury.
•
Read the additional Safety & Operating instructions booklet before using tool.
•
Do not use oxygen and combustible gases as an energy source for pneumatically operated tools.
•
The operation of this tool can cause sparks and act as a source of ignition for flammable fuels and gases
m IMPORTANT! Tool Operation:
•
To identify the operation type of your model, check the ID label affixed to the tool/ rear of this manual
and the corresponding row in the table at the front of this manual for that model. Read the corresponding
section in the Safety & Operating instructions for information of each trip type.
OPERATING YOUR MCN NAILER
TO AVOID SERIOUS INJURY FROM FASTENERS AND FLYING DEBRIS WHEN INSTALLING METAL CONNECTORS
USING THE MCN NAILER:
• Use only genuine BOSTITCH metal connector nails.
• Use only one stick of metal connector nails at a time.
• Metal connector nails are not designed to penetrate metal. When installing metal connectors, always place the
exposed point of the metal connector nail into the metal connector's pre-formed hole, and orient so the nail is
perpendicular to the hole before attempting to drive a fastener.
FIG 1- shows correct placement

TOOL OPERATION

NOTE: Although this is not the only pneumatic tool offered by BOSTITCH that operates sequentially, its
operation is unique from all other BOSTITCH tools. The moveable nose, which acts as the contact trip, is in the
"depressed" position at rest to allow visibility of the nail points used for positive placement. When the tip of the
nail is placed in the preformed metal connector hole and the trigger is pulled, the moveable nose moves out from
the tool to detect the work surface. If the moveable nose does not detect the work surface close to
the nose of the tool, the tool will not actuate.
Fig 2- shows incorrect placement
GB