Installing The Perimeter Cable - NOVARDEN NRL630 Manual De Instalación

EN

Installing the perimeter cable

Charging station direction
Install the perimeter cable in a clockwise direction:
connect one end of the cable to the charging station's Left
terminal (G) and pass it underneath the charging station.
Pull the cable in a straight line at least 2 m. Then mark
out the areas in your garden in a clockwise direction.
Close the loop by connecting the perimeter cable to the
Right terminal (D) maintaining a distance of at least 1 m
minimum. Never cross the IN and OUT cables to avoid
cancelling out the signal.
The perimeter cable allows you to mark out on the ground the area
that must not be passed during the mowing cycle. The cable must
make a loop around the robot mower's working area.
The loop starts with the "Out
cable (Figure 1). Ensure the cable is securely underneath the charging
station and connected to the outlet so that it does not move. Only
use the perimeter cable provided.
NOTE: Before connecting the perimeter cable to the right terminal, cut the end
closest to the charging station, taking care to leave a margin of 5-10 cm.
" cable and is closed off by the "In
A
A
G D
B
Figure 1
10
"
B