Checking Function - Prebena 1GP-A16 Manual Del Usuario

Preparing the tacker
 Ensure that the lower pusher (7) engages at the lock (4).
 Push the lock (4) forwards if necessary.
The magazine is closed.

Checking function

To check correct operation of the tacker, proceed as follows:
CAUTION
 Observe the danger notes in the chapter on 'Safety' from page
7 ff.
 Set the tool lug of the tacker on a piece of wood with a minimum
thickness of 20 mm.
 Trigger the tacker (see chapter "Triggering device" on page 21).
 Check the following properties:
-
Every time the device is triggered, a fastener must be driven
into the piece of wood.
-
To achieve the desired driving depth, alter the operating
pressure of the compressor (see page 15).
 Repeat these steps if necessary.
The tacker is not ready for operation.
18