MISTING FUNCTION
USING THE FAN WITH A WATER
BUCKET (NOT INCLUDED) (Fig. 6)
WARNING:
into buckets and drown. Keep children
away from buckets containing even a
small amount of liquid.
NOTICE: Clean the bucket with soap
and water before each use.
1. Disconnect the battery pack.
2. Place the bucket on a flat, level surface.
3. Add ONLY clean, cold water into the bucket. Do not overfill.
4. Immerse the filter end of the intake tube down into the water bucket.
NOTICE: Do not bend the intake tube, and always make sure the water flows smoothly
through the tube.
5. Install the battery pack and close the battery compartment cover.
6. Press the power button to turn the fan ON.
7. Press the misting mode selection button to start misting:
◾
Press the misting mode selection button once and the misting indicator will light
up one green light which indicates the 'continuous' misting mode – misting all the
time without stopping.
NOTICE: It may take around 15 seconds before you actually see the mist coming out of
the misting nozzles the first time. This delay is due to the time it takes for water to flow
from the water bucket to the nozzles.
◾
Press the misting mode selection button again and the misting indicator will light
up two green lights which indicates the 'intermittent' misting mode – misting for
5s every 10s.
◾
When the misting is in intermittent mode, press the misting mode selection button
again and the misting indicator lights will turn off and the misting will stop.
56V LITHIUM-ION CORDLESS MISTING FAN — FN1800/FN1800-FC
Children can fall
6
21