Cobra 1046 Manual De Utilización página 11

DOOR UNLOCKING DOOR UNLOCKING DOOR UNLOCKING
DOOR UNLOCKING DOOR UNLOCKING
• Press button "B" on the radio control to unlock the doors (Fig. 2)
• The turn indicators will blink twice.
NOTE NOTE
NOTE NOTE NOTE. In certain vehicles (Golf / Passat), button "B" winds down the windows
when the button is kept depressed.
RADIO CONTROL FUNCTIONS RADIO CONTROL FUNCTIONS RADIO CONTROL FUNCTIONS
RADIO CONTROL FUNCTIONS RADIO CONTROL FUNCTIONS
Door locking
Door unlocking
Window winding
RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW
If the LED flashes for a short time or in an irregular way when one of the buttons
is pressed, this means that the battery is low. Change the battery as indicated in
figure 3. figure 3. figure 3.
figure 3. figure 3.
1. 1. 1. 1. 1. To change the battery, open the radio control taking care to lever in the zone
marked "OPEN".
2. 2. 2. 2. 2. Take out the old battery.
3. 3. 3. 3. 3. Wait approx. 10 seconds.
4. 4. 4. 4. 4. Insert the new battery complying with the polarity indications and taking
care to only touch the side walls with the fingers.
5. 5. 5. 5. 5. Close the radio control and press button "A" twice, checking the response
from the system. Conduct the test near the vehicle.
6. 6. 6. 6. 6. Dispose of the old battery in one of the specially provided containers.
FAULTY OPERATION OF THE RADIO CONTROL FAULTY OPERATION OF THE RADIO CONTROL FAULTY OPERATION OF THE RADIO CONTROL FAULTY OPERATION OF THE RADIO CONTROL FAULTY OPERATION OF THE RADIO CONTROL
(How to carry out the re-synchronizing procedure) (How to carry out the re-synchronizing procedure) (How to carry out the re-synchronizing procedure)
(How to carry out the re-synchronizing procedure) (How to carry out the re-synchronizing procedure)
If the radio control fails to function and having made sure that the battery is not low,
proceed with the following operations at about 1 meter from the vehicle (fig. 4)
A) A) A) A) A) Press both buttons on the radio control until the LED changes its status from flashing to
off. Release the buttons (the LED will remain permanently on).
B) B) B) B) B) Press button "A" on the radio control and make sure that the LED flashes. The re-
synchronizing procedure will have now terminated.
C) C) C) C) C) Press button "A" again to make sure that the radio control operates correctly.
Button A Button A Button A Button B Button B Button B
Button A Button A Button B Button B
• • • • •
•
•
(Fig. 2) (Fig. 2)
(Fig. 2) (Fig. 2).
(fig. 4): (fig. 4) (fig. 4)
(fig. 4)
I
GB
11