76
Installation
• Electrical or installation work needs to be performed by a qualified
service personnel. There is risk of fire, electric shock, explosion or injury.
• The replacement of parts of the safety suspension system device shall be
performed by the manufacturer, its service agent or suitably qualified persons.
• Do not install the appliance less than 2.3 m from the ground and 1 m
from the wall to the blades.
• Ensure that the ceiling hook or other safey suspension devices shall
sustain more than 10 times the appliance weight.
• Ensure that the shaft has been fully tighten to motor shaft and shackle.
• Firmly tighten the blade screws using a screwdriver.
• Do not install the appliance in a place where flammable liquids or
gases such as gasoline, propane, paint thinner, etc., are stored.
• Do not install the appliance somewhere exposed to direct sunlight.
• Do not install the appliance in an area prone to combustible gas leaks,
grease, or metal dust.
• If the supply cord is damaged, it must be replaced by manufacturer or
service personnel in order to avoid hazard.
• Always ground the product.
− There is risk of fire or electric shock.
Operation
• Connect this appliance as per the rated voltage and frequency printed
on the name plate.
• Do not touch the power switch with wet hands.
• Do not disassemble, repair, modify or touch the appliance while it is
operating.
• Do not insert hands or any objects into the appliance.
• Do not place any objects on the appliance.
• Take care to ensure that power cable could not be pulled out or
damaged during operation.
− There is risk of fire or electric shock.
4
EN