Depth Adjustment - Delta 37-071 Manual De Instrucciones

TO CALIBRATE THE 45° INWARD AND OUTWARD STOPS:
1. Loosen the beveling lock by rotating the handle
counterclockwise.
2. Refer to Figure 18 and locate the two sets of 45°
Stop Bolts (A), there are two bolts that set the
position for the inward 45° Stop and two that set
the position for the outward 45° stop.
3. Loosen the two retaining nuts on the appropriate
set of Stop bolts and adjust the Stop bolts either in
or out.
NOTE: The heads of both Stop bolts must be flush
against the mount assembly.
4. Re-tighten the retaining nut and re-lock the
beveling lock. Then re-check the angle using the
carpenter's square. Continue to adjust as needed.

DEPTH ADJUSTMENT

Disconnect the machine from the
power source before making any
adjustments!
®
The DELTA 37-071 Bench Jointer is designed to
remove no more than 1/8" of stock in a single pass. For
operations requiring the removal of more stock, make
several passes to achieve the desired dimensions.
OPERATION
1. To adjust the depth of cut, rotate the infeed table
height adjustment wheel. Turning the wheel
clockwise raises the table (reducing the depth of
cut) while rotating it counterclockwise lowers the
table (increasing the depth of cut).
15
FIGURE 18